Sterling Shower Door Installation

Sterling Shower Door Installation

Sterling Shower Door Installation

Sterling Shower Door Installation – Today you’re going to learn how to install the legend Series shower door within one inline panel by, Coastal Industries start by un-boxing your unit make sure you have all the right parts a list of parts is included in your instruction determine and mark the curb centerline with adjustment holes facing toward interior of the Shower door position the wall jamb against the wall et cetera on the satellite market using the wall jamb’s installation holes as guides drill three one inch deep installation holes.

Use a three sixteenths inch masonry bit when drilling Into tile, marble or any other Masonary type surface insert Plastic Screw Anchors secure Wall jamb with three number eight by one and one-half inch pan head screws take your shower door panel and slide it over the wall jamb take your side panels and install over the shower door panel make sure that the shower door and Pannel have Been equally adjusted on all expansion points securit unit to the remaining wall by telescoping inline panels secure the jamb with three installation Self drilling Screws 0:01:22.080,0:01:27.040 Three more to secure the wall jamb to the shower door panel and three more to secure the panels and measure the opening.

Width At the top of the unit Trim header to 1/16th inch shorter Than width optained position the header in place Secure it using three self Tapping Screws To ensure watertight operation, 0:01:47.190,0:01:49.850 run a clear bead of caulk around outside of the Shower door

Leave a Comment