Pelpro Pp130 Control Board

Pelpro Pp130 Control Board

Pelpro Pp130 Control Board

Pelpro Pp130 Control Board – We’ll share with you how to properly replace the control board in your SP 130 pellet stove. The tools needed for today’s project are a number two phillips screw driver and seven sixteenths inch socket driver. To start today’s project first make sure your stove is completely cool and then remove the power cord from the back of the stove using your socket driver. Loosen the bolt on the bottom left-hand side of the stove once loose the side panel can easily be opened once you open. The Control Panel locate the control board and unplug the white molex plug at the bottom of the control board being careful not to pull the wires loose from the plug. Now going back to the outside the control panel remove the four screws securing the control board once these four screws have been removed.

You can now easily remove the control board from the side panel above the stove. Now to install the new control board set it in place and replace the four screws, you removed previously secure those tightly with your screwdriver. Now going back to the inside of the stove connect the molex plug to the bottom. The control panel making sure the retaining clips snaps properly. Now simply close the side panel above the stove and tighten the bolt. You loose and earlier you can then plug the stove back into the wall and tested for proper operation.

Leave a Comment